General Small Vaneaxial Information

These are compact, high-speed fans whose airflow is parallel to the motor shaft.  The impeller and guide vanes are of airfoil construction for maximum aerodynamic efficiency and minimum acoustical noise.

Vaneaxial fans are designed for use in tightly packaged airborne “black boxes” where sizes and weight must be held to an absolute minimum, where

reliability is critical, and where high heat loads must be dissipated with cooling air.

Rotron AXIMAX 1

Note: See specific part-number drawing for complete product dimensions.

• Physical envelope:   1.75” Dia. x 1.70” L
• Weight:  approximately 4 ounces
• Specially designed for spot cooling of electronics and optics.
• Custom mounting configurations such as flanges or servo rings and synclamps are available, please contact the Application Engineering deparment for more information. 

• All aluminum components are finished with a black anodized coating per MIL-C-8625. The shaft and hardware are of corrosion-resistant stainless steel.
• The impeller runs on two high-precision, double-shielded, stainless steel ball bearings (ABEC, Class 5) with an integral lubricant reservoir for long, maintenance-free life.
• The stator is wound in accordance with the specifications for Class F insulation. 

• Permanent split phase capacitor run and 3
• phase motor designs
• Fixed speeds (performance) based on input frequency.
• Meets or exceeds the requirements of MIL-B-23071 and other applicable U.S. military specifications

Direct Connection (lead wires or MS connector)

• Free delivery airflow of 2.5 at 60 Hz and 21 CFM at 400 Hz
• Ambient temperature range:  -54°C to 125°C
• Acoustic levels as low as 60 dBA
• Airflow, maximum ambient and acoustic levels will vary depending on design parameters

DELTAC^®Converter Driven Units

• DELTAC^® converters allow 50 through 400 Hz fans to be driven by 50 or 60 Hz power to obtain the higher frequency performance

DC Powered Units - E.C.D.C. ^®     

• Brushless SmCo permanent magnet design (Electronically Commutated DC)
• Speed (performance) not fixed by input
• frequency as in ac powered units.
• Meets or exceeds the requirements of MIL-B-28873 and other applicable U.S. military specifications

Direct Connection (lead wires)

• Free delivery airflow of 17.4 CFM
• Ambient temperature range:  -54°C to 100°C
• Acoustic levels as low as 69 dBA
• Airflow, maximum ambient and acoustic levels will vary depending on design parameters

BATAC^®Inverter Driven Units

• AC square wave fans are driven from a DC power source through a BATAC^® Inverter.
• Low cost alternative when multiple fans are used in a single application or area.
• Allows for greater than 100 VDC input voltage

Options/Accessories

• Synclamp

• LSWD (low speed warning device)
• FPS (fan performance sensor)

The unit description key is for reference only and should not be confused with an order form.  While most units are custom configurations, not all variations of the key shown below are possible.  Please contact the Application Engineering department for more information regarding possible custom configurations.